Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1565

To return to the default, use the no timers throttle lsa command. Parameters start-interval hold-interval max-interval Set the minimum interval between initial sending and resending the same LSA. The range is from 0 to 600,000 milliseconds. Set the next interval to send the same LSA. This interval is the time between sending the same LSA after the start-interval has been attempted. The range is from 1 to 600,000 milliseconds. Set the maximum amount of time the system waits before sending the LSA. The range is from 1 to 600,000 milliseconds. Defaults • start-interval: 0 msec • hold-interval: 5000 msec • max-interval: 5000 msec Command Modes ROUTER OSPF Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.8.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Usage Information LSAs are sent after the start-interval and then after hold-interval until the maximum interval is reached. In throttling, exponential backoff is used when sending same LSA, so that the interval is multiplied until the maximum time is reached. For example, if the start-interval 5000 and hold-interval 1000 and max-interval 100,000, the LSA is sent at 5000 msec, then 1000 msec, then 2000 msec, them 4000 until 100,000 msec is reached. timers throttle lsa arrival Configure the LSA acceptance intervals. C9000 Series Syntax timers throttle lsa arrival arrival-time Open Shortest Path First (OSPFv2 and OSPFv3) 1565