Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 114

Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 9.1(0.0) 8.3.19.0 8.3.11.1 7.6.1.0 7.5.1.0 E-Series Description Introduced on the C9010 and C1048P. Introduced on the Z9500. Added 'conditional' parameter. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S-Series. Introduced on the C-Series. Original command. Usage Information If there is a change in the configuration, the system prompts you to save the new configuration. Or you can save your running configuration with the copy runningconfig command. Use the conditional parameter if any configuration changes made to the nvram, such as stack-group and fanout configurations, must be saved. To halt a port extender (PE) or an entire PE stack, and perform a cold-restart (from a PE console), use the reload command. send Send messages to one or all terminal line users. C9000 Series Syntax Parameters Defaults send [*] | [line ] | [console] | [vty] * line console vty Enter the asterisk character * to send a message to all tty lines. Send a message to a specific line. The range is from 0 to 11. Enter the keyword console to send a message to the primary terminal line. Enter the keyword vty to send a message to the virtual terminal. none Control and Monitoring 114