Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 272

Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.8.1.0 7.6.1.0 7.5.1.0 6.2.1.1 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Increase the name string to accept up to 140 characters. Prior to 7.8.1.0, names were up to 16 characters long. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. ip access-group Assign an IP access list (IP ACL) to an interface. C9000 Series Syntax ip access-group access-list-name {in | out} [implicit-permit] [vlan vlan-id] To delete an IP access-group configuration, use the no ip access-group accesslist-name {in | out} [implicit-permit] [vlan vlan-id] command. Parameters access-list-name in out implicit-permit Enter the name of a configured access list, up to 140 characters. Enter the keyword in to apply the ACL to incoming traffic. Enter the keyword out to apply the ACL to outgoing traffic. (OPTIONAL) Enter the keyword implicit-permit to change the default action of the ACL from implicit-deny to implicitpermit (that is, if the traffic does not match the filters in the ACL, the traffic is permitted instead of dropped). Access Control Lists (ACL) 272