Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 926

Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 7.4.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Modified for E-Series: Revised from 78 to 240 characters. Usage Information Important Points to Remember: • To use special characters as a part of the description string, you must enclose the whole string in double quotes. • Spaces between characters are not preserved after entering this command unless you enclose the entire description in quotation marks ("desc_text"). • Entering a text string after the description command overwrites any previous text string that you previously configured as the description. • The shutdown and description commands are the only commands that you can configure on an interface that is a member of a port-channel. • Use the show interfaces description command to display descriptions configured for each interface. Related Commands show interfaces - displays information about an interface. default interface Resets a physical interface to its factory-default settings. C9000 Series Syntax Parameters default interface interface slot/port-range interface slot/ port-range Enter one of the following interface types and port information to specify a single port or a range of ports. To specify a port range, you can enter a hyphenated range and/or individual port numbers separated with commas; for example, default interface tengigabitethernet 1/0-4,7,9-11. To enter any random number of ports, you can enter a comma-separated Interfaces 926