Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 2085

Version 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 7.5.1.0 Description Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Usage Information When you enable logging synchronous, unsolicited messages appear between software prompts and outputs. Only the messages with a severity at or below the set level are sent to the console. If the message queue limit is reached on a terminal line and messages are discarded, a system message appears on that terminal line. Messages may continue to appear on other terminal lines. Related Commands logging on - enables logging. logging trap Specify which messages are logged to the Syslog server based the message severity. C9000 Series Syntax logging trap [level] To return to the default values, use the default logging trap command. To disable logging, use the no logging trap command. Parameters level Indicate a value from 0 to 7 or enter one of the following parameters: emergencies, alerts, critical, errors, warnings, notifications, informational, or debugging. The default is 6 or informational. Defaults 6 or informational Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Simple Network Management Protocol (SNMP) and Syslog 2085