Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 605

warning-only percentage of the maximum value, the software sends a message. The range is 1 to 100 percent. The default is 75. (OPTIONAL) Enter the keywords warning-only to set the router to send a log message when the maximum value is reached. If you do not set this parameter, the router stops peering when the maximum number of prefixes is reached. Defaults threshold = 75 Command Modes ROUTER BGPV6-ADDRESS FAMILY Command History Version Description 9.9(0.0) Introduced on the C9010. 9.2(1.0) Introduced on the Z9500. 8.2.1.0 Introduced on the E-Series ExaScale. 7.4.1.0 Introduced Usage Information If you configure the neighbor maximum-prefix command and the neighbor receives more prefixes than allowed by the neighbor maximum-prefix command configuration, the neighbor goes down and the show ip bgp summary command displays (prfxd) in the State/PfxRcd column for that neighbor. The neighbor remains down until you enter the clear ip bgp command for the neighbor or the peer group to which the neighbor belongs or you enter the neighbor shutdown and neighbor no shutdown commands. Related Commands show ip bgp summary - displays the current BGP configuration. neighbor next-hop-self Allows you to configure the router as the next hop for a BGP neighbor. (This command is used for IBGP). C9000 Series Syntax neighbor {ipv6-address | peer-group-name} next-hop-self To return to the default setting, use the no neighbor {ipv6-address | peergroup-name} next-hop-self command. Parameters ipv6-address Enter the IPv6 address in the x:x:x:x::x format. NOTE: The :: notation specifies successive hexadecimal fields of zeros. peer-group-name (OPTIONAL) Enter the name of the peer group. Border Gateway Protocol 605