Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1445

unit unit-number range is from 0 to 7; and the port-id range is from 1 to 48 hardware_address Enter a 48-bit hardware MAC address in nn:nn:nn:nn:nn:nn format. vrf vrf-name (Optional) Enter the keyword vrf and the name of the VRF to install IPv6 routes in that VRF. Defaults none Command Modes CONFIGURATION CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.10(0.0) 9.9(0.0) 9.8(0.0) 9.7(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.1 Description Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Added support for VRF. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Usage Information Neighbor Discovery Protocol for IPv6 is defined in RFC 2461 as part of the Stateless Address Autoconfiguration protocol. It replaces the Address Resolution Protocol used with IPv4. It defines mechanisms for solving problems, such as: • Router discovery: Hosts can locate routers residing on a link • Prefix discovery: Hosts can discover address prefixes for the link. • Parameter discovery • Address autoconfiguration - configuration of addresses for an interface • Address resolution - mapping from IP address to link-layer address • Next-hop determination• Neighbor Unreachability Detection (NUD): Determine that a neighbor is no longer reachable on the link • Duplicate Address Detection (DAD): Allow a node to check whether a proposed address is already in use. • Redirect: The router can inform a node about a better first-hop. Neighbor Discovery Protocol (NDP) 1445