Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1270

NOTE: The :: notation specifies successive hexadecimal fields of zeros. Defaults none Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 9.1(0.0) 9.0.0.0 8.3.19.0 8.3.7.0 8.4.1.0 8.2.1.0 7.8.1.0 7.4.1.0 Description Introduced on the C9010. Introduced on the Z9500. Updated Usage Information. Introduced on the Z9000. Introduced on the S4820T. Introduced on the S4810. Added support on the management Ethernet port. Introduced on the E-Series ExaScale. Introduced on the C-Series and S-Series. Introduced on the E-Series TeraScale. Usage Information • If two addresses are configured, delete an existing address before configuring a new address. • If the last manually-configured global IPv6 address is removed using the "no" form of the command, the link-local IPv6 address is removed automatically. • IPv6 addresses on a single management interface cannot be members of the same subnet. • IPv6 secondary addresses on management interfaces across platform must be members of the same subnet. • IPv6 secondary addresses on management interfaces should not match the virtual IP address and should not be in the same subnet as the virtual IP. Example Dell(conf)#interface tengigabitethernet 1/0 Dell(conf-if-te-1/0)#ipv6 address ? X:X:X:X::X IPv6 address Dell(conf-if-te-1/0)#ipv6 address 2002:1:2::3 ? Prefix length in bits Dell(conf-if-te-1/0)#ipv6 address 2002:1:2::3 /96 ? Dell(conf-if-te-1/0)#ipv6 address 2002:1:2::3 /96 Dell(conf-if-te-1/0)#show config ! IPv6 Basics 1270