Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 910

Parameters lincard slot-id / all Enter the keyword linecard with the slot-id to specify a linecard, or all to select all linecards. Linecard ID. Range is from 0 to 11. pe pe-id / all Enter the keyword pe and the port extender ID or type the option all to select all port extenders. Range is from 0 to 255. stack unit unitnumber Enter the keyword stack-unit and the configuration is applied to all the stack-units present in the PE. rpm Enter the keyword rpm to disable auto-reboot of the failed RPM. Default Disabled (that is, the failed module is automatically rebooted). Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(0.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.3.1.0 8.1.1.0 7.6.1.0 Description Introduced on the C9010. Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux (PMUX) mode only. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Added the all option. Introduced on the E-Series ExaScale. Introduced on the E-Series Usage Information Enabling this command keeps the failed module (RPM, PE, or Linecard) in the failed state. If there are two RPMs or PEs in the system, enabling this command prevents the failed RPM or PE from becoming a working Standby RPM or PE. If there is only one RPM or PE in the system, the failed RPM or PE does not recover and affects the system. Example: PE Dell(conf)#redundancy disable-auto-reboot pe 1 stack-unit High Availability (HA) 910