Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1251

You can configure ACL logging only on ACLs that are applied to ingress interfaces; you cannot enable logging for ACLs that are associated with egress interfaces. You can activate flow-based monitoring for a monitoring session by entering the flowbased enable command in the Monitor Session mode. When you enable this capability, traffic with particular flows that are traversing through the ingress and egress interfaces are examined and, appropriate ACLs can be applied in both the ingress and egress direction. Flow-based monitoring conserves bandwidth by monitoring only specified traffic instead all traffic on the interface. This feature is particularly useful when looking for malicious traffic. It is available for Layer 2 and Layer 3 ingress and egress traffic. You may specify traffic using standard or extended access-lists. This mechanism copies all incoming or outgoing packets on one port and forwards (mirrors) them to another port. The source port is the monitored port (MD) and the destination port is the monitoring port (MG). ipv6 access-list Configure an access list based on IPv6 addresses or protocols. C9000 Series Syntax ipv6 access-list access-list-name To delete an access list, use the no ipv6 access-list access-list-name command. Parameters access-list-name Enter the access list name as a string, up to 140 characters. Defaults Command Modes All access lists contain an implicit "deny any"; that is, if no match occurs, the packet is dropped. CONFIGURATION CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.10(0.0) 9.9(0.0) Description Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. IPv6 Access Control Lists (IPv6 ACLs) 1251