Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1167

• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. • For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE then the pe-id, stack-unit unit number, and port-ID. The pe-id range is 0-255; the stackunit unit number range is 0-7; and the port-id range is 0- 48. Defaults Not configured. Command Modes CONFIGURATION CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.10(0.0) 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.5.1.0 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 6.2.1.0 Description Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Added support for 4-port 40G line cards on ExaScale. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information You cannot use Class D or Class E IP addresses or zero IP address (0.0.0.0) when creating a static ARP. Zero MAC addresses (00:00:00:00:00:00) are also invalid. Use this command in Configuration Terminal Batch mode to associate an IP address with a MAC address in a dual-homing setup. NOTE: The parameters vrf, mac-address, and interface are not supported in the batch mode. Related Commands clear arp-cache - clears dynamic ARP entries from the ARP table. show arp - displays the ARP table. IPv4 Routing 1167