Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1788

Command Modes CONFIGURATION CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.10(0.0) 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.3.16.0 Description Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the MXL 10/40GbE Switch IO Module. Usage Information To apply dot1p-queue-mapping, use the service-class dynamic dot1p command. Use this command in Configuration Terminal Batch mode to apply the dot1p-queuemapping in a dual-homing setup. Related Commands show qos dot1p-queue-mapping - displays the dot1p priority to queue mapping on the switch. service-class dynamic dot1p Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all interfaces (from CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE mode entry. C9000 Series Syntax service-class dynamic dot1p To return to the default setting, use the no service-class dynamic dot1p command. Defaults All dot1p traffic is mapped to Queue 0 unless you enable the service-class dynamic dot1p command. The default mapping is as follows: Quality of Service (QoS) 1788