Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 649

cam-acl-pe Allocate content addressable memory (CAM) for the port extender. C9000 Series Syntax Parameters cam-acl-pe [default| l2acl number ipv4acl number ipv6acl number ipv4qos number l2qos number ipmacacl number] default l2acl ipv4acl ipv6acl ipv4qos l2qos ipmacacl Resets ACL CAM entries to default setting. Allocates space for the L2 ACL. The default value is 5. Allocates space for the L3 ACL. The default value is 2. Allocates space for the IPv6 L3 ACL. The default value is 2. Allocates space for the L3 QoS. The default value is 2. Allocates space for L2 QoS. The default value is 1. (Optional) Allocates space for IP and MAC ACLs. The default value is 0. Defaults None Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command-Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) Description Introduced on the C9010. Usage Guidelines Select the CAM allocation for Layer 2, IPv4, and IPv6 ACLs, Layer 2 and Layer 3 (IPv4) QoS, Layer 2 Protocol Tunneling (L2PT), IP and MAC source address validation for DHCP, and Policy-based Routing (PBR). Save the new CAM settings to the startupconfig (write-memor copy run start) then reload the system for the new settings to take effect. The total amount of space allowed is 12 FP Blocks. System flow requires three blocks; these blocks cannot be reallocated. The ipv4acl profile range is from 1 to 4. When configuring space foripv6acl, the total number of Blocks must equal 13. Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which is from 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10). If allocation values are not entered for the CAM regions, the value is 0. Content Addressable Memory (CAM) 649