Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 2274

maximum dynamic-routes Specify the maximum number of dynamic (protocol) routes a VRF can have. C9000 Series Syntax maximum dynamic-routes limit {warn-threshold threshold-value | warning-only} To remove the limit on the maximum number of routes used, use the no maximum dynamic-routes command. Parameters limit warningthreshold warning-only Maximum number of routes allowed in a VRF. Valid range is from 1 to 16,000 (or maximum allowable for that platform if smaller value). Warning threshold value is expressed as a percentage of the limit value. When the number of routes reaches the specified percentage of the limit, a warning message is generated. Valid range is 1 to 100. When warn-threshold is used, once the limit is reached, additional dynamic routes will not be allowed. When the warning-only option is used, a syslog message will be thrown when maximum number of dynamic routes reaches the limit. Additional dynamic routes will still allowed. Defaults No limit is set on the maximum number of dynamic routes for a VRF. Command Modes CONFIGURATION-VRF Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OSCommand Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.8(0.0) 9.7(0.0) 9.4(0.0) Description Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Introduced on the S6000-ON and Z9500. Introduced on the S-Series. Virtual Routing and Forwarding (VRF) 2274