Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 2269

ipv6 route-export Enable route leaking between VRFs. Export or share IPv6 routes corresponding to one VRF with other nondefault VRFs. C9000 Series Syntax Parameters ipv6 route-export tag [route-map-name] route-export tag route-map-name Enter the keyword route-export to leak or share routes between VRFs. Enter a tag (ASN number) as the export route target to expose routes to other VRFs. This tag acts as an identifier for exported routes. You can use this identifier while importing these routes into another non-default VRF. (Optional) Enter the name of the route-map to filter the exported routes. You can leak global routes to be made available to VRFs. As the global RTM usually contains a large pool of routes, when the destination VRF imports global routes, these routes will be duplicated into the VRF's RTM. As a result, it is mandatory to use route-maps to filter out leaked routes while sharing global routes with VRFs. Defaults N/A Command Modes VRF MODE CONFIGURATION Command History Version 9.9(0.0) 9.8(0.0) 9.7(0.0) Description Introducued on the C9010. Introduced on the S3048-ON and S4048-ON. Introduced on the S4810, S4820T, S5000, S6000, S6000-ON, and Z9500. Usage Information You can use the ip route-export tag command without specifying the route-map attribute to export all the routes corresponding to a source VRF. This action exposes source VRF's routes to various other VRFs, which then import these routes using the ip route-import tag command. In Dell Networking OS, you can configure at most one route-export per VRF as only one set of routes is exposed for leaking. However, you Virtual Routing and Forwarding (VRF) 2269