Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 928

Related Commands interface Vlan 33 private-vlan mode isolated no ip address shutdown show running-config- displays the current configuration. duplex (Management) Set the mode of the Management and Port Extender Gigabit Ethernet (PeGigE) interfaces. C9000 Series Syntax duplex {half | full} To return to the default setting, use the no duplex command. Parameters half full Enter the keyword half to set the Management interface to transmit only in one direction. Enter the keyword full to set the Management interface to transmit in both directions. Defaults Not configured. Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.11.1 8.1.1.0 7.5.1.0 7.4.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000. Introduced on the E-Series ExaScale. Introduced on the C-Series. Documentation modified - added Management to distinguish from duplex (10/100 Interfaces). Usage Information This command applies to the Management interface on the route processor modules (RPMs) and port extender (PE) ports. Interfaces 928