Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 2255

track Monitor an interface and lower the priority value of the VRRP group on that interface if it is disabled. C9000 Series Syntax track interface [priority-cost cost] To disable monitoring, use the no track interface command. Parameters interface OPTIONAL) Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Loopback interface, enter the keyword loopback followed by a number from 0 to 16383. • For a Port Channel interface, enter the keywords portchannel followed by the number. The range of portchannel IDs is 1 to 128. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For SONET interfaces, enter the keyword sonet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword FortyGigE followed by the slot/port information. • For a tunnel interface, enter the keyword tunnel followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by the VLAN ID. The VLAN ID range is from 1 to 4094. • For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE followed by the pe-id /stack-unit unit number / port-ID number. priority-cost (OPTIONAL) Enter a number as the amount to be subtracted from the priority value. The range is 1 to 254. The default is 10. Defaults priority cost = 10 Command Modes VRRP Command History Version 9.9(0.0) 9.8(0.0) 9.7(0.0) Description Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Introduced on the S6000-ON. Virtual Router Redundancy Protocol (VRRP) 2255