Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 2270

Related Commands can configure multiple route-import targets because a VRF accepts routes from multiple VRFs. You can expose a unique set of routes from the source VRF for leaking to other VRFs. When two VRFs leak or export routes, there is no option to discretely filter leaked routes from each source VRF. You cannot import one set of routes from one VRF and another set of routes from another VRF. Only active routes are eligible for leaking. For example, if one VRF has two routes corresponding to BGP and OSPF, in which the BGP route is not active, the OSPF route takes precedence over BGP. Even though the Target VRF has specified filtering options to match BGP, the BGP route is not leaked as that route is not active in the Source VRF. ipv6 route-import - imports IPv6 routes from another VRF. ipv6 route-import Import IPv6 routes leaked by another VRF using the tag specified by that VRF during export of these routes. C9000 Series Syntax Parameters ipv6 route-import tag [route-map-name] route-import tag route-map-name Enter the keyword route-import to import IPv6 routes into the VRF. Enter a tag (ASN number) to specify an import route target for importing routes from another VRF. To import leaked routes from another VRF, you must use the same ASN number that is specified as the export route target at the source VRF. Enter the name of the route-map to filter the imported routes. NOTE: You must use the route-map attribute while importing routes from the global RTM. Route-maps enable you to filter routes at the import end based on the matching criteria that you define in the route-map. Command Modes VRF MODE CONFIGURATION Command History Version 9.9(0.0) Description Introduced on the C9010. Virtual Routing and Forwarding (VRF) 2270