Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1807

Usage Information To access this command, enter the class-map command. After the class map is identified, you can configure the match criteria. The match ip dscp and match ip precedence commands are mutually exclusive. Up to 64 IP DSCP values can be matched in one match statement. For example, to indicate IP DCSP values 0 1 2 3 4 5 6 7, enter either the match ip dscp 0,1,2,3,4,5,6,7 or match ip dscp 0-7 command. NOTE: Only one of the IP DSCP values must be a successful match criterion, not all of the specified IP DSCP values must match. Related Commands class-map - identifies the class map. match ip precedence Use IP precedence values as a match criteria. C9000 Series Syntax match {ip | ipv6 | ip-any} precedence ip-precedence-list [set-ipdscp value | set-color value ] To remove IP precedence as a match criteria, use the no match {ip | ipv6 | ipany} precedence ip-precedence-list [[multicast] set-ip-dscp value| set-color value command. Parameters ip ipv6 ip-any ip-precedencelist set-ip-dscp value set-color value Enter the keyword ip to support IPv4 traffic. Enter the keyword ipv6 to support IPv6 traffic. Enter the keyword ip-any to support IPv4 and IPv6 traffic. Enter the IP precedence value(s) as the match criteria. Separate values by commas - no spaces ( 1,2,3 ) or indicate a list of values separated by a hyphen (1-3). The range is from 0 to 7. (Optional) Enter the keywords set-ip-dscp then the IP DSCP value. The matched traffic is marked with the DSCP value. The range is from 0 to 63. (Optional) Enter the keyword set-color followed by a color value. Traffic that fulfills the match criteria is marked with the color value that you specify. The default value is Yellow. Defaults none Command Modes CLASS-MAP CONFIGURATION (config-class-map) Quality of Service (QoS) 1807