Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 953

Example Example Example (Vlan) Related Commands an untagged member of VLAN 10, which becomes the native VLAN of the port. The port now accepts: • untagged frames and classify them as VLAN 10 frames • VLAN 20 tagged frames The following describes the do show interfaces command shown in the following example. This example shows output with "Hybrid" as the newly added value for 802.1QTagged. The options for this field are: • True - port is tagged • False - port is untagged • Hybrid - port accepts both tagged and untagged frames The following describes the interface vlan command shown in the following example. This example shows unconfiguration of the hybrid port using the no portmode hybrid command. NOTE: Remove all other configurations on the port before you can remove the hybrid configuration from the port. Dell(conf)# interface te 2/0 Dell(conf-if-te-2/0)# portmode hybrid Dell(conf-if-te-2/0)# interface vlan 10 Dell(conf-if-vl-10)# untagged te 2/0 Dell(conf-if-vl-10)# interface vlan 20 Dell(conf-if-vl-20)# tagged te 2/0 Dell(conf-if-vl-20)# Dell(conf-if-vl-20)# do show interfaces switchport Name: TenGigabitEthernet 2/0 802.1QTagged: Hybrid Vlan membership: Vlan 10, Vlan 20 Native VlanId: 10 Dell(conf-if-vl-20)# Dell(conf-if-vl-20)# interface vlan 10 Dell(conf-if-vl-10)# no untagged te 2/0 Dell(conf-if-vl-10)# interface vlan 20 Dell(conf-if-vl-20)# no tagged te 2/0 Dell(conf-if-vl-20)# interface te 2/0 Dell(conf-if-te-2/0)# no portmode hybrid Dell(conf-if-vl-20)# • show interfaces switchport - displays the configuration of switchport (Layer 2) interfaces on the switch. • switchport - places the interface in a Layer 2 mode. • vlan-stack trunk - specifies an interface as a trunk port to the Stackable VLAN network. Interfaces 953