Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 611

neighbor route-map Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group. C9000 Series Syntax neighbor {ipv6-address | peer-group-name} route-map map-name {in | out} To remove the route map, use the no neighbor {ipv6-address | peer-groupname} route-map map-name {in | out} command. Parameters ipv6-address Enter the IPv6 address in the x:x:x:x::x format. NOTE: The :: notation specifies successive hexadecimal fields of zeros. peer-group-name Enter the name of the peer group. map-name Enter the name of an established route map. If you do not configure the Route map, the default is deny (to drop all routes). in Enter the keyword in to filter inbound routes. out Enter the keyword out to filter outbound routes. Defaults Not configured. Command Modes ROUTER BGPV6-ADDRESS FAMILY Command History Version Description 9.9(0.0) Introduced on the C9010. 9.2(1.0) Introduced on the Z9500. 8.2.1.0 Introduced on the E-Series ExaScale. 7.4.1.0 Introduced Usage Information When you apply a route map to outbound routes, only routes that match at least one section of the route map are permitted. If you identify a peer group by name, the peers in that peer group inherit the characteristics in the Route map used in this command. If you identify a peer by IP address, the Route map overwrites either the inbound or outbound policies on that peer. Border Gateway Protocol 611