Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1707

seq Configure a filter with an assigned sequence number for the redirect list. C9000 Series Syntax Parameters seq sequence-number {permit | redirect {ip-address | tunnel tunnel-id}[track ] }} {ip-protocol-number | protocol-type} {source mask | any | host ip-address} {destination mask | any | host ip-address} [bit] [operator]{source-port source-port| sourceport-range start-port - end-port} {destination-port destinationport| destination-port-range start-port - end-port} To delete a filter, use the no seq sequence-number command. sequencenumber permit redirect ip-address tunnel tunnel-id track track ip-protocolnumber protocol-type source Enter a number from 1 to 65535. Enter the keyword permit assign the sequence to the permit list. Enter the keyword redirect to assign the sequence to the redirect list. Enter the keyword IP address of the forwarding router. Enter the keyword tunnel to configure the tunnel setting. Enter the keyword tunnel-id to redirect the traffic. Enter the keyword track to enable the tracking. Enter the keyword track to track object-id. Enter the keyword ip-protocol-number then the number from 0 to 255 for the protocol identified in the IP protocol header. Enter one of the following keywords as the protocol type: • icmp for internet control message protocol • ip for any internet protocol • tcp for transmission control protocol • udp for user datagram protocol Enter the IP address of the network or host from which the packets were sent. Policy-based Routing (PBR) 1707