Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 201

boot system Specify the location where the Dell Networking OS image used to boot the system is stored. C9000 Series Syntax Parameters boot system [gateway ip address | [rpm0 {default | primary | secondary [ftp: | system:{A:| B:} | tftp:] }] [rpm1 {default | primary | secondary [ftp: |system:{A:|B:} | tftp:]}] gateway ip-address rpm0 rpm1 default primary secondary ftp: system A: | B: tftp: Enter the IP address of the default next-hop gateway for the management subnet. Enter an IP address in dotted decimal format. Enter the keyword rpm0 to specify the route processor module 0. Enter the keyword rpm1 to specify the route processor module 1. Enter the keyword default to use the default Dell Networking OS image. Enter the keyword primary to use the primary Dell Networking OS image. Enter the keyword secondary to use the secondary Dell Networking OS image. Enter the keyword FTP: to retrieve the image from an FTP server: ftp://userid:password @host-ip/filepath. Enter A: or B: to boot one of the flash system partitions. Enter the keyword TFTP: to retrieve the image from a TFTP server: tftp://host-ip/filepath. Defaults Not configured. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. File Management 201