Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1035

Command History Version 9.9(0.0) 9.2.1.0 9.3.0.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000 platform. Defaults The default trigger-threshold value is 60. Usage Information The trigger-threshold of bandwidth usage, which determines when the calculation of link-bundle utilization is performed, is set at 60 percent of the link-bundle bandwidth. When the total traffic use (mean) is below the trigger-threshold percentage, unevenness in link-bundle traffic distribution is not reported. If traffic unevenness is detected in three consecutive measurements, an alarm is issued. The time interval between measurements is defined by the rate interval for HiGig link polling (default 15 seconds). show hardware hg-stats Display the traffic statistics from internal ports in a HiGig link bundle/port channel on a line-card or switch fabric module (SFM) NPU. C9000 Series Syntax Parameters show hardware {sfm npu-id | linecard slot} hg-stats {port hg-port- number | unit npu-id port hg-port-number} sfm npu-id linecard slot hg-stats {port hgport-number | unit npu-id port hg-port-number} Specify a switch SFM (spine) NPU by entering the keyword sfm and SFM NPU ID. Valid SFM NPU IDs are 0 to 1. Specify a line-card (leaf) NPU by entering the keyword linecard and line-card slot. Valid slot numbers are 0 to 11. Enter the keyword hg-stats to display HiGig port statistics. For an SFM NPU HiGig link bundle, specify only a HiGig port number. Valid SFM hg-port-number values are 1 to 33. For a line-card NPU HiGig link bundle, specify an NPU ID and a HiGig port number. Line-card NPUs range is 0. Line-card HiGig port numbers range from 27 to 32. Defaults Command Modes none • EXEC • EXEC Privilege Interfaces 1035