Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1185

Usage Information To stop packets from flooding the user terminal when debugging is turned on, use the count option. The access-group option supports only the equal to (eq) operator in TCP ACL rules. Port operators not equal to (neq), greater than (gt), less than (lt), or range are not supported in access-group option (refer to the following example). ARP packets (arp) and Ether-type (ether-type) are also not supported in the access-group option. The entire rule is skipped to compose the filter. The access-group option pertains to: • IP protocol number: from 0 to 255 • Internet control message protocol (icmp) but not the ICMP message type (from 0 to 255) • Any internet protocol (ip) • Transmission Control Protocol (tcp) but not on the rst, syn, or urg bits • User Datagram Protocol (udp) If an ambiguous access control list rules, the debug ip packet access-control command is disabled. A message appears identifying the error (refer to the following Example). Example (Error Messages) Dell#debug ip packet access-group test %Error: port operator GT not supported in access-list debug %Error: port operator LT not supported in access-list debug %Error: port operator RANGE not supported in access-list debug %Error: port operator NEQ not supported in access-list debug Dell#00:10:45: %RPM0-P:CP %IPMGR-3-DEBUG_IP_PACKET_ACL_AMBIGUOUS_EXP: Ambiguous rules not supported in access-list debug, access-list debugging is turned off Dell# deny arp (for Extended MAC ACLs) Configure an egress filter that drops ARP packets on egress ACL supported line cards. (For more information, refer to your line card documentation). C9000 Series Syntax deny arp {destination-mac-address mac-address-mask | any} vlan vlan-id {ip-address | any | opcode code-number} [count [byte]] [order] [log [interval minutes] [threshold-in-msgs [count]] [monitor] IPv4 Routing 1185