Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 543

To return to the default, use the no timers bgp command. Parameters keepalive holdtime Enter a number for the time interval, in seconds, between keepalive messages sent to the neighbor routers. The range is from 1 to 65535. The default is 60 seconds. Enter a number for the time interval, in seconds, between the last keepalive message and declaring the router dead. The range is from 3 to 65535. The default is 180 seconds. Defaults none Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.7.1.0 7.6.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. MBGP Commands Multiprotocol BGP (MBGP) is an enhanced BGP that enables multicast routing policy throughout the internet and connecting multicast topologies between BGP and autonomous systems (ASs). MBGP on the Dell Networking OS is implemented as per IETF RFC 1858. BGPv4 is supported in the following: Version 9.9(0.0) 9.2(1.0) 7.8.1.0 Platform Support C9010 Z9500 TeraScale and C-Series (MBGP for IPv6) Border Gateway Protocol 543