Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1187

You can activate flow-based monitoring for a monitoring session by entering the flowbased enable command in the Monitor Session mode. When you enable this capability, traffic with particular flows that are traversing through the ingress and egress interfaces are examined and, appropriate ACLs can be applied in both the ingress and egress direction. Flow-based monitoring conserves bandwidth by monitoring only specified traffic instead all traffic on the interface. This feature is particularly useful when looking for malicious traffic. It is available for Layer 2 and Layer 3 ingress and egress traffic. You may specify traffic using standard or extended access-lists. This mechanism copies all incoming or outgoing packets on one port and forwards (mirrors) them to another port. The source port is the monitored port (MD) and the destination port is the monitoring port (MG). ip address Assign a primary and secondary IP address to the interface. C9000 Series Syntax ip address {ip-address mask [secondary] | dhcp} To delete an IP address from an interface, use the no ip address [ip-address] command. Parameters ip-address mask secondary dhcp Enter an IP address in dotted decimal format. Enter the mask of the IP address in slash prefix format (for example, /24). (OPTIONAL) Enter the keyword secondary to designate the IP address as the secondary address. Enter the keyword dhcp to configure an interface to receive its IP address from the configured DHCP server. Defaults Not configured. Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) Description Introduced on the C9010. IPv4 Routing 1187