Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 2000

Defaults Not configured. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.7(0.0) 9.5(0.1) 9.4(0.0) Description Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S-Series and Z9000. Usage Information The source-interface interface attribute is applicable for both the SSH client as well as the COPY (SCP) commands. Using these attributes the client session tags an error to the user during run time, in case there is a mismatch between this command and the ip ssh vrf command. Example Dell(conf)#ip ssh source-interface tengigabitethernet 0/36 Dell(conf)#do ssh 10.10.10.2 -l admin Dell(conf)#no ip ssh source-interface show crypto Display the public part of the SSH host-keys. C9000 Series Syntax Parameters NOTE: Some of the parameters in this command require licensing to access. For more information, contact your Dell Networking representative. show crypto key mypubkey {rsa | rsa1} Key mypubkey rsa rsa1 Enter the keyword key to display the host public key. Enter the keyword mypubkey to display the host public key. Enter the keyword rsa to display the host SSHv2 RSA public key. Enter the keyword rsa1 to display the host SSHv1 RSA public key. NOTE: If you enable FIPS mode, this parameter is not available. Defaults none Security 2000