Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 337

Parameters mac-list-name Enter a text string as the name of the standard MAC access list (140 character maximum). Defaults Not configured. Command Modes CONFIGURATION CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.10(0.0) 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.8.1.0 7.6.1.0 7.5.1.0 6.1.1.0 Description Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16 characters long. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information The system supports one ingress and one egress MAC ACL per interface. The number of entries allowed per ACL is hardware-dependent. For detailed information on the number entries allowed per ACL on the C9000, refer to the Content Addressable Memory (CAM) chapter in the C9000 Configuration Guide. Use this command in Configuration Terminal Batch mode to configure a standard MAC ACL, name in a dual-homing setup. Example Dell(conf)#mac-access-list access-list standard TestMAC Dell(config-std-macl)#? deny Specify packets to reject description List description exit Exit from access-list configuration mode no Negate a command or set its defaults permit Specify packets to forward remark Specify access-list entry remark Access Control Lists (ACL) 337