Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1759

Parameters pe pe-id Enter the keyword pe and the port extender ID. Range is from 0 to 255. stack-unit unit number Enter the keyword stack-unit and the stack unit number Range is from 0 to 7. interface interface Enter the interface keyword, and specify one of the following interface types: • For a PE Gigabit Ethernet interface, enter the keyword peGigE. You must specify a pe-id/Unit/Port for the interface. . Defaults Command Modes None • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) Description Introduced on the C9010. Usage Information The following describes the output fields of the show power inline command: Field Interface Inline Power Allocated Inline Power Consumed Class Description Displays the line card or the port extender interface slot and port number. Displays the amount of power allocated to the port. Displays the amount of power consumed by the connected device. Displays the power classification of the connected device. If the device is powered up properly, it displays Class 0, 1, 2, 3, or 4. Displays the following under different conditions: • NO_DEVICE if no device is present. • LEGACY if a legacy device is connected. • PD_S/C if a short-circuit condition is detected. • PD_OVRLD if overload condition is detected. Port Extenders (PE) 1759