Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1796

Defaults none Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.5.1.0 6.1.1.1 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the C-Series. Introduced on the E-Series. Usage Information The dot1p-priority command changes the priority of incoming traffic on the interface. The system places traffic marked with a priority in the correct queue and processes that traffic according to its queue. When you set the priority for a port channel, the physical interfaces assigned to the port channel are configured with the same value. You cannot assign the dot1p-priority command to individual interfaces in a port channel. rate police Police the incoming traffic rate on the selected interface. C9000 Series Syntax Parameters rate police [kbps] committed-rate [burst-KB] [peak [kbps] peakrate [burst-KB]] [vlan vlan-id] kbps committed-rate burst-KB peak peak-rate Enter the keyword kbps to specify the rate limit in Kilobits per second (Kbps). Enter the bandwidth in Mbps. The range is from 0 to 40000. (OPTIONAL) Enter the burst size in KB. The range is from 16 to 200000. The default is 50. (OPTIONAL) Enter the keyword peak then a number to specify the peak rate in Mbps. The range is from 0 to 40000. Quality of Service (QoS) 1796