Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1871

rmon hc-alarm Set an alarm on any MIB object. C9000 Series Syntax Parameters rmon hc-alarm number variable interval {delta | absolute} risingthreshold value event-number falling-threshold value event-number [owner string] To disable the alarm, use the no rmon hc-alarm number command. number variable interval delta absolute rising-threshold value eventnumber falling-threshold value eventnumber owner string Enter the alarm integer number from 1 to 65535. The value must be unique in the RMON alarm table. The MIB object to monitor. The variable must be in the SNMP OID format; for example, 1.3.6.1.2.1.1.3 The object type must be a 64-bit integer. Time, in seconds, the alarm monitors the MIB variables; this is the alarmSampleType in the RMON alarm table. The range is from 5 to 3600 seconds. Enter the keyword delta to test the change between MIB variables. This is the alarmSampleType in the RMON alarm table. Enter the keyword absolute to test each MIB variable directly. This is the alarmSampleType in the RMON alarm table. Enter the keywords rising-threshold then the value (64 bit) the rising-threshold alarm is either triggered or reset. Then enter the event-number to trigger when the rising threshold exceeds its limit. This value is the same as the alarmRisingEventIndex or alarmTable of the RMON MIB. If there is no corresponding rising-threshold event, the value is zero. Enter the keywords falling-threshold then the value (64 bit) the falling-threshold alarm is either triggered or reset. Then enter the event-number to trigger when the falling threshold exceeds its limit. This value is the same as the alarmFallingEventIndex or the alarmTable of the RMON MIB. If there is no corresponding falling-threshold event, the value is zero. (OPTIONAL) Enter the keyword owner then the owner name to specify an owner for the alarm. This is the alarmOwner object in the alarmTable of the RMON MIB. Remote Monitoring (RMON) 1871