Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 556

To delete the site-of-origin community, use the no set extcommunity command. Parameters as4 ASN4:NN ASN:NNNN IPADDR:NN non-trans Enter the keyword as4 then the 4-octet AS specific extended community number in the format ASN4:NN (4-byte AS number: 2-byte community value). Enter the 2-octet AS specific extended community number in the format ASN:NNNN (2-byte AS number:4-byte community value). Enter the IP address specific extended community in the format IPADDR:NN (4-byte IPv4 Unicast Address:2-byte community value). (OPTIONAL) Enter the keywords non-trans to indicate a nontransitive BGP extended community. Defaults none Command Modes ROUTE MAP (config-route-map) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.7.1.0 7.6.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information If the set community rt and soo are in the same route-map entry, the behavior defines as: • If the rt option comes before soo, with or without the additive option, soo overrides the communities rt sets. • If the rt option comes after soo, without the additive option, rt overrides the communities soo sets. • If the rt with the additive option comes after soo, rt adds the communities soo sets. Border Gateway Protocol 556