Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1729

Version 9.10(0.0) Description Introduced on the C9010. Usage Information The Configuration Terminal Batch mode is used to setup common configurations on a port extender connected in a dual-homing environment. Use the commit command to apply the configuration changes. In the Configuration Terminal Batch mode, you can continue to commit the changes without exiting the batch mode. Example Example with multiple Commits: Dell#configure terminal batch Peer is registered Dell(conf-b)#interface peGigE 184/0/1 Dell(conf-b-if-pegi-184/0/1)#no shutdown Dell(conf-b-if-pegi-184/0/1)#commit Dell(conf-b)#Apr 5 06:48:28: %RPM1-P:CP %CLIBATCH-6CLI_BATCH_CONFIG_IN_PROGRESS_TRAP: Batch configuration commit is in progress Apr 5 06:48:28: %RPM1-P:CP %IFMGR-5-ASTATE_UP: Changed interface Admin state to up: PeGi 184/0/1 Apr 5 06:48:28: %RPM1-P:CP %CLIBATCH-6CLI_BATCH_CONFIG_COMPLETE_TRAP: Batch configuration commit is success Dell(conf-b)#interface peGigE 184/0/1 Dell(conf-b-if-pegi-184/0/1)#switchport Dell(conf-b-if-pegi-184/0/1)#int vla 1000 Dell(conf-b-if-vl-1000)#tagged peGigE 184/0/1 Dell(conf-b-if-vl-1000)#commit Dell(conf-b)#Apr 5 06:48:47: %RPM1-P:CP %CLIBATCH-6CLI_BATCH_CONFIG_IN_PROGRESS_TRAP: Batch configuration commit is in progress Apr 5 06:48:47: %RPM1-P:CP %IFMGR-5-ACTIVE: Changed Vlan interface state to active: Vl 1000 Apr 5 06:48:48: %RPM1-P:CP %CLIBATCH-6CLI_BATCH_CONFIG_COMPLETE_TRAP: Batch configuration commit is success discard Use the discard command to cancel the uncommitted changes made to common configurations in the Configuration Terminal Batch mode. C9000 Series Syntax discard Default None Command Modes CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. Port Extenders (PE) 1729