Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 2159

Example The software clock runs only when the software is up. The clock restarts, based on the hardware clock, when the switch reboots. Dell Networking recommends using an outside time source, such as NTP, to ensure accurate time on the switch. Dell#clock set 16:20:00 19 may 2001 Dell# clock summer-time date Set a date (and time zone) on which to convert the switch to daylight saving time on a one-time basis. C9000 Series Syntax Parameters clock summer-time time-zone date start-month start-day start-year start-time end-month end-day end-year end-time [offset] To delete a daylight saving time zone configuration, use the no clock summer-time command. time-zone start-month start-day start-year start-time end-day end-month end-time Enter the three-letter name for the time zone. This name is displayed in the show clock output. Enter the name of one of the 12 months in English. You can enter the name of a day to change the order of the display to time day month year. Enter the number of the day. The range is from 1 to 31. You can enter the name of a month to change the order of the display to time day month year. Enter a four-digit number as the year. The range is from 1993 to 2035. Enter the time in hours:minutes. For the hour variable, use the 24-hour format; example, 17:15 is 5:15 pm. Enter the number of the day. The range is from 1 to 31. You can enter the name of a month to change the order of the display to time day month year. Enter the name of one of the 12 months in English. You can enter the name of a day to change the order of the display to time day month year. Enter the time in hours:minutes. For the hour variable, use the 24-hour format; example, 17:15 is 5:15 pm. System Time and Date 2159