Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 794

stack-unit unitnumber port-set number counters Enter the stack-unitunit-number parameters to specify a stack-unit. The stack-unit range is from 0 to 7. Enter the keyword port-set number parameters to specify a port pipe (set of ports) on a line card. The port set number is 0. Enter the keyword counters to display counter statistics. Defaults none Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Usage Information The port-set values are internal port numbers.For more information on the interfaces and port numbers, see the Debugging and Diagnostics chapter in the Dell Networking OS Configuration Guide for the C9000 System. Example Dell#show hardware mac in-acl pe 8 stack-unit 0 port-set 0 EID 0x00000c00: gid=0x5, slice=6, slice_idx=0, part =0 prio=0xc00, flags=0x10602, Installed, Enabled tcam: color_indep=1024, Stage InPort DATA=0x0000000000000000000000000000000000000000000000001000000000 MASK=0x00000000000000000000000000000000000000000000fdffffffffffff InPorts DATA=0x0000000000000000000000000000000000000000000000001000000000 MASK=0x00000000000000000000000000000000000000000000fdffffffffffff HiGig Offset: 320 Width: 1 DATA=0x00000000 MASK=0x00000001 SrcMac Offset: 89 Width: 48 DATA=0x00000000 08000000 MASK=0x0000ffff ffffffff action={act=CopyToCpuCancel, param0=0(0), param1=0(0), param2=0(0), param3=0(0)} action={act=EtagNew, param0=65772(0x100ec), param1=0(0), param2=0(0), param3=0(0)} policer= Debugging and Diagnostics 794