Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1755

Example Dell(conf)#power inline legacy pe 0 stack-unit 0 power inline mode Configures PoE power management mode for a specified port extender. C9000 Series Syntax Parameters power inline mode {pe pe-id stack-unit unit number class | static } pe pe-id stack-unit unit number class static Enter the keyword pe and port extender ID. Range is 0-255. Enter the keyword stack-unit and the unit number. Range is 0-7. Enter the keyword class to configure the class mode for the specified port extender. Enter the keyword static to configure the static mode for the specified port extender. Defaults Static Command Modes CONFIGURATION CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.10(0.0) 9.9(0.0) Description Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Usage Information The power inline mode command allows you to manage inline power supply on the port extender (PE) ports. You can configure class or static mode to manage inline power in a port extender. When class mode is configured, maximum power for the particular class of device is allocated. Class mode supports power allocation via Layer 2 classification and power negotiation by Link Layer Discovery Protocol (LLDP) 802.3at standard . When static mode is configured, the inline power is allocated based on the actual power Port Extenders (PE) 1755