Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 647

There can be only one odd number of Blocks in the CLI configuration; the other Blocks must be in factors of 2. For example, a CLI configuration of 5+4+2+1+1 Blocks is not supported; a configuration of 6+4+2+1 Blocks is supported. The ipv6acl allocation must be a factor of 2. If allocation values are not entered for the CAM regions, the value is 0. If you enable BMP, to perform a reload on the chassis to upgrade any configuration changes that have changed the NVRAM content, use the command reload conditional nvram-cfg-change. cam-acl-egress Allocate CAM for egress ACLs. C9000 Series Syntax Parameters cam-acl-egress default | l2acl number ipv4acl number ipv6acl number} default l2acl number ipv4acl number ipv6acl number Reset egress CAM ACL entries to default settings. Allocate space to each CAM region. Enter the CAM profile name then the amount of CAM space to be allotted. The total space allocated must equal 13. The range for ipv4acl is from 1 to 4. The ipv6acl range must be a factor of 2. Command Modes CONFIGURATION CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.10(0.0) 9.9(0.0) 9.2(1.0) 8.3.19.0 Description Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Content Addressable Memory (CAM) 647