Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1720

The following is a list of the Dell Networking OS version history for this command. Version 9.10(0.0) 9.9(0.0) Description Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Usage Information Before you provision a port extender, enable the extended bridge feature using the feature extended-bridge command. The pe provision pe-id command logically pre-provisions or adds a port extender (PE) even when the PE is not physically connected to the switch. The port extender ID (pe-id) range is from 0 to 255. After provisioning a PE using the pe provision pe-id , you can provision a stack unit using the stack-unit command. You can provision a port extender connected in a Dual-Homing setup from the Configuration Terminal Batch mode. To de-provision a port extender, use the no pe provision pe-id command. NOTE: You must ensure that the port extender units are offline before you issue the no pe provision command. Example Related Commands DELL(conf)# pe provision 10 DELL(conf-pe-10)# DELL(conf)# no pe provision 10 • feature extended-bridge • stack unit • show pe show config Display the PE provision configuration details. C9000 Series Syntax show config Command Modes PE CONFIG (conf-pe-pe-id) Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Port Extenders (PE) 1720