Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 938

• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. • For a VLAN interface, enter the keyword vlan then a number from 1 to 4094. • For a Tunnel interface, enter the keyword Tunnel then a number from 1 to 16383. • For a Port Extender Gigabit Ethernet interface, enter the keyword peGigE then the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255; the stackunit unit-number range is from 0 to 7; and the port-id range is from 1 to 48. Defaults none Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.5.1.0 8.2.1.0 8.1.1.0 7.6.1.0 7.5.1.0 6.1.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Added support for 4-port 40G line cards on ExaScale. Added support for 4093 VLANs on E-Series ExaScale. Prior releases supported 2094. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information When creating an interface range, interfaces appear in the order they are entered; they are not sorted. The command verifies that interfaces are present (physical) or configured (logical). Important Points to Remember: • Bulk configuration is created if at least one interface is valid. • Non-existing interfaces are excluded from the bulk configuration with a warning message. • The interface range prompt includes interface types with slot/port information for valid interfaces. The prompt allows for a maximum of 32 Interfaces 938