Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 349

seq Configure a filter with a specific sequence number. C9000 Series Syntax seq sequence-number {deny | permit} {any | host mac-address | macsource-address mac-source-address-mask} {any | host mac-address | mac-destination-address mac-destination-address-mask} [ethertype operator] [count [byte]] [log [interval minutes] [threshold-inmsgs [count]] [monitor] To delete a filter, use the no seq sequence-number command. Parameters sequencenumber deny permit any host mac-address mac-sourceaddress Enter a number as the filter sequence number. The range is from zero (0) to 65535. Enter the keyword deny to drop any traffic matching this filter. Enter the keyword permit to forward any traffic matching this filter. Enter the keyword any to filter all packets. Enter the keyword host and then enter a MAC address to filter packets with that host address. Enter a MAC address in nn:nn:nn:nn:nn:nn format. The MAC ACL supports an inverse mask; therefore, a mask of ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of 00:00:00:00:00:00 only allows entries that match exactly. mac-sourceaddress-mask mac-destinationaddress mac-destinationaddress-mask Specify which bits in the MAC address must be matched. Enter the destination MAC address and mask in nn:nn:nn:nn:nn:nn format. Specify which bits in the MAC address must be matched. The MAC ACL supports an inverse mask; therefore, a mask of ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of 00:00:00:00:00:00 only allows entries that match exactly. ethertype operator (OPTIONAL) To filter based on protocol type, enter one of the following Ethertypes: • ev2 - is the Ethernet II frame format. • llc - is the IEEE 802.3 frame format. Access Control Lists (ACL) 349