Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1253

Version 9.9(0.0) 9.2(1.0) 9.0.0.0 8.3.19.0 8.3.10.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000. Introduced on the S4820T. Introduced on the S4810. permit (for IPv6 ACLs) Configure a filter that matches the filter criteria, select an IPv6 protocol number, ICMP, IPv6, TCP, or UDP. C9000 Series Syntax Parameters Defaults permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp} [count [byte]] [dscp value] [order] [fragments] [log [interval minutes] [threshold-in-msgs [count]] [monitor] To remove this filter, you have two choices: • Use the no seq sequence-number command syntax if you know the filter's sequence number • Use the no permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp} command log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages. threshold-in msgs count (OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate the maximum number of ACL logs that can be generated, exceeding which the generation of ACL logs is terminated with the seq, permit, or deny commands. The threshold range is from 1 to 100. interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes at which ACL logs must be generated. The interval range is from 1 to 10 minutes. monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you want to monitor and the ACL in which you are creating the rule is applied to the monitored interface. By default, 10 ACL logs are generated if you do not specify the threshold explicitly. IPv6 Access Control Lists (IPv6 ACLs) 1253