Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1659

ip pim dr-priority Change the designated router (DR) priority for the interface. C9000 Series Syntax ip pim dr-priority priority-value To remove the DR priority value assigned, use the no ip pim dr-priority command. Parameters priority-value Enter a number. Preference is given to larger/higher number. The range is from 0 to 4294967294. The default is 1. Defaults 1 Command Modes INTERFACE INTERFACE (BATCH Mode) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.10(0.0) 9.9(0.0) 9.8(0.0) 9.7(0.0) 9.5(0.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.8.1.0 Description Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the C-Series on port-channels and the S-Series. Usage Information The router with the largest value assigned to an interface becomes the designated router. If two interfaces contain the same designated router priority value, the interface with the largest interface IP address becomes the designated router. PIM-Source Specific Mode (PIM-SSM) 1659