Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 315

Example Example Related Commands Most ACL rules require one entry in the CAM. However, rules with TCP and UDP port operators (for example, gt, lt, or range) may require more than one entry. The range of ports is configured in the CAM based on bit mask boundaries; the space required depends on exactly what ports are included in the range. An ACL rule with a TCP port range of 4000-8000 uses eight entries in the CAM. Rule# Data Mask From To #Covered 1 0000111110100000 1111111111100000 4000 4031 32 2 0000111111000000 1111111111000000 4032 4095 64 3 0001000000000000 1111100000000000 4096 6143 2048 4 0001100000000000 1111110000000000 6144 7167 1024 5 0001110000000000 1111111000000000 7168 7679 512 6 0001111000000000 1111111100000000 7680 7935 256 7 0001111100000000 1111111111000000 7936 7999 64 8 0001111101000000 1111111111111111 8000 8000 1 Total Ports: 4001 An ACL rule with a TCP port lt 1023 uses only one entry in the CAM. Rule# Data Mask From To #Covered 1 0000000000000000 1111110000000000 0 1023 1024 Total Ports: 1024 ip access-list extended - creates an extended ACL. permit - assigns a permit filter for IP packets. permit tcp - assigns a permit filter for TCP packets. resequence prefix-list ipv4 Re-assign sequence numbers to entries of an existing prefix list. C9000 Series Syntax Parameters resequence prefix-list ipv4 {prefix-list-name StartingSeqNum Stepto-increment} prefix-list-name StartingSeqNum Enter the name of the configured prefix list, up to 140 characters long. Enter the starting sequence number to resequence. The range is from 0 to 65535. Access Control Lists (ACL) 315