Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1220

Parameters interface (OPTIONAL) Enter the following keywords and slot/port or number information: • For a Loopback interface, enter the keyword Loopback then a number from 0 to 16383. • For the Management interface, enter the keyword ManagementEthernet then zero (0). • For the Null interface, enter the keyword null then zero (0). • For a Port Channel interface, enter the keywords portchannel then a number. The range is from 1 to 128. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. • For a tunnel interface, enter the keyword tunnel then the tunnel interface number. The range is from 1 to 16383. • For a VLAN, enter the keyword vlan then a number from 1 to 4094. linecard slot-id brief configured Enter the linecard slot-id parameters to specify the switch ports on a line card. The range of slot IDs is from 0 to 2. (OPTIONAL) Enter the keyword brief to view a brief summary of the interfaces and whether an IP address is assigned. (OPTIONAL) Enter the keyword configured to display the physical interfaces with non-default configurations only. Command Modes • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.5.1.0 8.3.7.0 8.1.1.2 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Added support for 4-port 40G line cards on ExaScale. Introduced on the S4810. Supported on the E-Series ExaScale E600i. IPv4 Routing 1220