Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 662

Parameters cp-switch all pe pe-id stack-unit unit number portset port-pipe ID Enter the keyword cp-switch to clear counters for rate-limited traffic on the central switch (aggregated CoPP). Enter the keyword all to clear counters for all protocol ratelimiting traffic information. Enter the keyword pe and the port extender ID. The PE ID range is from 0 to 255. Enter the keyword stack-unit and the stack unit number. The stack-unit range is from 0 to 7. Enter the keyword portset and the port-pipe ID. The port-pipe ID value is 0. Defaults Clear per-protocol rate-limiting counters for all control-plane and port-set (port-pipe) traffic. Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.8.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Usage Information To display the per-protocol counters of rate-limited control-plane traffic at the aggregated (switch) or line card and port set level, use the show control-traffic protocol command. clear control-traffic queue Clear per-queue counters of rate-limited control-plane traffic. C9000 Series Syntax clear contol-traffic queue {all | queue-number} counters Control Plane Policing (CoPP) 662