HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 123

EM-1005 9 EM-1005 Message , [EM-1005], , FFDC, CRITICAL, , has faulted. Sensor(s) above maximum limits Probable Cause Recommended Action Severity Indicates that a blade in the specified slot or the switch (for nonbladed switches) is being shut down for environmental reasons; its temperature or voltage is out of range. Check the environment and make sure the room temperature is within the operational range of the switch. Use the fanShow command to verify fans are operating properly. Make sure there are no blockages of the airflow around the chassis. If the temperature problem is isolated to the blade itself, replace the blade. Voltage problems on a blade are likely a hardware problem on the blade itself; replace the blade. CRITICAL EM-1006 Message , [EM-1006], , FFDC, CRITICAL, , has faulted. Sensor(s) below minimum limits Probable Cause Recommended Action Severity Indicates that the sensors show the voltage is below minimum limits. The switch or specified blade is being shut down for environmental reasons; the voltage is too low. If this problem occurs on a blade, it usually indicates a hardware problem on the blade; replace the blade. If this problem occurs on a switch, it usually indicates a hardware problem on the main board; replace the switch. CRITICAL EM-1007 Message , [EM-1007], , FFDC, CRITICAL, , is being reset. Sensor(s) has exceeded max limits Probable Cause Recommended Action Indicates that the voltage on a switch has exceeded environmental limits. A reset is sent to the faulty slot or the switch for nonbladed switches. There is most likely a voltage hardware problem on the blade or motherboard of the switch. For the SilkWorm 24000 and 48000, replace the blade FRU. For the SilkWorm 3900 replace the motherboard FRU. Fabric OS Message Reference 9-3 Publication Number: 53-1000242-01