HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 352

44 MS-1003 Recommended Action Severity The recommended actions are as follows: • No action is required. • Set the flag for the MS Platform Service. • Run the firmwareDownload command to upgrade the firmware level on the switch to a level that supports RCS. RCS is supported in Fabric OS v2.6, v3.1 and greater, and v4.1 and greater. • Wait a few minutes and try the command again. INFO MS-1003 Message , [MS-1003], ,, INFO, , MS detected Unstable Fabric(). Probable Cause Recommended Action Severity Indicates that MS detected an unstable fabric; the command or operation might not be successfully completed. This message is often transitory. The message string can be one of the following: • The domain is invalid for a request. • Unable to acquire the World Wide Name (WWN) for the corresponding domain. The domain number is the target domain that caused error. The fabric might be reconfiguring, forming, or merging. Wait a few minutes and try the operation again. Run the fabricShow command or the secFabricShow command to verify that the number of domains matches the Management Server known domains. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. INFO MS-1004 Message , [MS-1004], ,, INFO, , MS detected ONLY 1 Domain(d=). Probable Indicates that MS detected an unstable count of domains in its own local resource. Cause 44-2 Fabric OS Message Reference Publication Number: 53-1000242-01