HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 511

ZONE-1029 73 Probable Cause Recommended Action Severity Indicates that the zone database size is greater than the limit allowed by the fabric. The limit of the zone database size depends on the lowest level switch in the fabric. Older switches have less memory and force a smaller zone database for the entire fabric. Edit the zone database to keep it within the allowable limit for the specific switches in your fabric. Refer to the Fabric OS Administrator's Guide for information on the zone database sizes supported for each switch. WARNING ZONE-1029 Message , [ZONE-1029], ,, WARNING, , Restoring zone cfg from flash failed - bad config saved to [] Probable Cause Recommended Action Severity Indicates that the zone configuration restored from the flash was faulty. This error will save the faulty zone configuration in the zoned core file directory. Run the saveCore command to save the file. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. WARNING ZONE-1030 Message , [ZONE-1030], ,, WARNING, , Converting the zone db for PID format change failed Probable Cause Recommended Action Severity Indicates that the current zone database could not be converted to reflect the PID format change. Most likely this is caused by the size of the zone database. Change the PID format back to its original format. Reduce the size of the zone database. Then you can change the PID format to the requested format. WARNING Fabric OS Message Reference Publication Number: 53-1000242-01 73-9