HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 469

SWCH-1006 62 SWCH-1006 Message , [SWCH-1006], ,, WARNING, , HA state out of sync: Standby CP (ver = ) does not support NPIV functionality. (active ver = , NPIV devices = ) Probable Cause Recommended Action Severity Indicates that the standby CP does not support NPIV functionality and the switch has some NPIV devices logged into the fabric. Load a firmware version on standby that supports NPIV functionality, using the firmwareDownload command. WARNING SWCH-1007 Message , [SWCH-1007], ,, WARNING, , Switch port disabled due to \"\". Probable Cause Recommended Action Severity Indicates that the switch port is disabled due to the reason displayed in the message. Based on the disable reason displayed, proper corrective action may to be required to restore the port. If insufficient frame buffers is the disable reason, reduce the distance or speed settings for the port to reduce the buffer requirement of the link. Alternatively, one or more ports in the port group must be disabled to make more buffers available for the link. Please refer to the Fabric OS Administrator's Guide for more information about buffers. WARNING SWCH-1008 Message , [SWCH-1008], ,, WARNING, , are port swapped on ports that do not support port swap. Slot will be faulted. Probable Indicates that the blade is enabled with the port configuration that already has already area swapped. Cause Fabric OS Message Reference Publication Number: 53-1000242-01 62-3